BabyTrend CC13700 - EZ FLEX-LOC INFANT CAR SEAT - POMEGRANATE - Manual (Page 20)

7.1 Preparation
1. Park your vehicle on a level surface so that
the level indicator located on the left side
of the Infant Seat will properly indicate the
proper angle of recline of the seat.
2. Make sure you have selected an acceptable
location for the Infant Seat as instructed in
section Selecting the Best Location for
the Infant Seat on page 12.
3. Check again for any Active Air bags. DO
NOT use any location that has an active
air bag or is adjacent to an Active Air bag
such that, when deployed, the Active Air bag
may come into contact with the Infant Seat.
Many passenger side Active Air bags are
designed to deploy to protect the
passenger side as well as the center front
seating position. Please see the Active
Air bag warnings in your vehicle owner’s
manual to help determine unsafe locations
in the vehicle.
4. If the front seat position is used, slide the vehicle seat as far
to the rear as possible to prevent the Infant Seat from striking
the dash in a crash. If the rear seat position is used, slide the
vehicle seat directly in front of the Infant Seat forward enough
to prevent the Infant Seat from striking the vehicle seat back in
a crash.
7.0
INSTALLATION
7.0
INSTALLATION
39 38
5. Check that the vehicle seat back is locked in the upright
position and will not fold forward onto the Infant Seat.
(Fig. 39-1)
7.2 Installation of the Infant Seat / Vehicle
Belt Installation of Base:
1. Remove the Infant Seat from the base
by squeezing the base release handle
located under the center of the foot end of
the Infant Seat and lifting upward on the
Infant Seat (See Fig. 25-1). Store both
UAS connectors as shown in Fig. 44-1.
2. If you are using the Base with the Infant
Seat, place the Base in the rear-facing
position in a forward facing vehicle seat
as shown in Fig. 39-2. If you are using
the Infant Seat without the Base, place
the Infant Seat in a rear-facing position
in a forward facing vehicle seat as
shown in Fig. 40-1. The Child must face
the rear of the vehicle and Infant Seat
must be placed in a vehicle seat that
faces forward.
3. See Fig. 39-2 for the proper threading of
the vehicle belt through the Base and Fig.
40-1 for the proper threading of the belt
through the Infant Seat without the Base.
Fig. 39-1
Fig. 39-2
Folding seat must
be locked
Lap/Shoulder Belt
Lap Belt only