BabyTrend CC13700 - EZ FLEX-LOC INFANT CAR SEAT - POMEGRANATE - Manual (Page 25)

proper angle of recline, place a rolled
towel, or car seat noodle, under the
base at the foot end to achieve the
correct position. (Fig. 48-1)
2. Infant Seat without Base: Check that
the Infant Seat is level side to side on the
vehicle seat. Check the level indicator as
shown in Fig. 46-2.
• If the Seat Angle Indicator shows NO
red, the seat is installed at the proper
level of recline.
• If the Seat Angle Indicator shows ANY
red , the Infant Seat is either too upright
or too reclined . If the Infant Seat is too
reclined adjust the Infant Seat as shown
in Fig. 48-2 until the level indicator
shows NO red . If the Infant Seat is too
upright, place a tightly rolled towel, or
car seat noodle, under the foot end of
the Infant Seat until the level indicator
shows NO red . (Fig. 48-3) Re-tighten the
vehicle seat belt as instructed in section
Securing the Infant Seat or Base in the
Vehicle.
7.0
INSTALLATION
49 48
Fig. 48-1
Fig. 48-2
Fig. 48-3
8.0
FINAL CHECKS
FINAL SAFETY CHECKS
1. If your child is already in the Infant Seat, check that the
harness is properly fitted and tight as instructed in the section
6.1, Securing your Child in the Infant Seat / Carrier.
2. Make sure that the Infant Seat is tightly installed and secure
in the vehicle by performing the following test every time you
use the Infant Seat. Firmly push down and side to side on
the head end of the Infant Seat to make sure that the vehicle
seat belt does not loosen at all and that the vehicle seat belt is
fastened very tightly around the Infant Seat / Base. If you find
that the vehicle seat belt loosens or that the seat easily moves
or rotates downward, please see section entitled Selecting the
Best Location for the Infant Seat to determine if the position
you have selected is adequate and check that you have
completed all of the steps in the section entitled Securing the
Infant Seat or Base in the Vehicle.
DO NOT use this seating location if the Infant Seat does not
remain tightly installed in the vehicle seat!
3. Place handle in mid storage or non-rocking position after
installing in the vehicle.