BabyTrend PY86091 - DELUXE NURSERY CENTER - MESA - Manual (Page 4)

Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved. Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
ASSEMBLY ASSEMBLY
5 6
ATTENTION: Some playard maybe fully
assemble. If so, skip to step 5.
3. Attach the Legs to the Playard by pushing each
Leg into the bottom of the leg mount until both
sides snap firmly into place (Fig. 3).
IMPORTANT: Check that each Leg is
securely attached before use.
4. Attach the Wheels to the Playard using the
axles, retainers and caps provided. Align each
Wheel and insert axle through the center
(Fig. 4). Secure by pushing the retainer over
the end of the axle until it snaps into place
(Fig.5). Finish by pushing the cap over the
end of the axle and retainer until it snaps into
place (Fig. 5).
IMPORTANT: Check that each Wheel is
securely attached before use.
NOTE: To operate the brakes on the Wheels,
press downward on the brake levers. To
release, lift upward on the lever (Fig. 6)
5. Turn the Playard right side up and keep the
Legs and Wheels close together. Stretch out
top of Playard and pull up one side at a time of
each of the top rails until each latch “Clicks”
and locks securely into place (Fig. 7).
NOTE: The best way to lock the rail(s) is to
hold one hand on each side and pull up sharply.
(DO NOT pull from the middle where the latch
release is located).
IMPORTANT: The handle located in the
center of the Playard floor MUST remain raised
(Approx. 45.7 cm or 18 inches) while locking
the side rails in place. If the center is not raised
the rails will NOT lock.
If you experience difficulty and one side of the
rail will lock but the other side will not then,
unlock the rail by squeezing the release in the
center and try again. If you still have difficulty,
contact our Customer Service Center at
1-800-328-7363 or visit us online at
www.babytrend.com.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
6. Once all four (4) top rails are locked in place,
push down on the center handle (Fig. 8). The
center mechanism will rotate clockwise 90
degrees and automatically lock in place.
IMPORTANT: Test each top rail by pushing
down slightly to confirm each is rigid and
locked securely in place before use (Fig.9) .
ATTENTION:
To use as a bassinet, skip to page 7 for bassinet
installation instructions.
7. Place the Mattress on the floor of the Playard
with the padded side facing up (Fig. 10)
8. Feed the three (3) hook and loop straps located
on the underside of the Mattress through the
slots in the floor of each end of the Playard
(Fig. 11). Fasten the hook and loop straps to
the underside of the Playard floor to prevent the
Mattress from moving (Fig. 12).
Fig. 4
Insert
axle from
outside
Outside Inside
Fig. 5
Fig. 7
Fig. 6
Fig. 3
Right leg Left leg