BabyTrend PY86091 - DELUXE NURSERY CENTER - MESA - Manual (Page 6)

Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved. Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
ATTENTION:
Playard must be fully assembled and securely
locked before installing or using the bassinet
feature. (See To Assemble Playard section)
You will need to remove the mattress from the
bottom of the Playard to use inside your Bassinet.
1. Position the Bassinet over and down into the
fully assembled Playard. Secure in place by
pushing down firmly on each plastic support
clip until all are snapped into place (Fig. 18).
2. Assemble Mattress Support Tubes (if
equipped; otherwise, skip to step 4) by
inserting the two (2) male tubes into the two
(2) female tubes (Fig. 19).
3. Insert both, assembled, Mattress Support
Tubes into the loops provided on the bottom
of the Bassinet (Fig. 20).
4. Place the Mattress into the Bassinet with the
padded side facing upward (Fig. 21)
NOTE: Fasten tabs underneath the Mattress
secure it in place.
TO REMOVE BASSINET
1. Remove Mattress from Bassinet.
2. Remove Canopy.
3. Unsnap all clips and lift Bassinet.
ASSEMBLY
9 10
Fig. 18
Fig. 19
Fig. 20
Fig. 21
TO ASSEMBLE CANOPY
ATTENTION:
If the equipped Canopy comes in "U" shape
(Fig. 22), you need to assemble the Canopy before
attach to the playard. If the Canopy comes in "C"
shape, skip to step 3.
1. Open Canopy as seen in Fig. 23, make
opening adjustments at the top of Canopy by
aligning the inner center strap with the two
outer straps. (Fig 24.)
ASSEMBLY
Fig. 24
Fig. 23
Fig. 22
Bassinet
Metal Support Tubes
(2 male, 2 female)
Inner center strap
Outer strap
Outer strap
TO ASSEMBLE BASSINET
“C” Shape Canopy “U” Shape Canopy
or