American Car Craft Dodge Challenger Grille Lower Trim Ring Polished 2011-2013 User Manual
Page 2
3.
Take the promoter (included) and swipe the entire area where your trim will stick to.
This will insure a nice strong bond long term. The promoter is clear and will not damage
or stain your paint.
4.
Without removing the rear red liner - set the trim ring in place to get acquainted with
the position as well as just how you will set the ring in place. The attachment tape is
very aggressive and will not allow you to reposition the ring once you have set it in
position so take your time positioning the ring.
TECH TIP: Using your thumbs to the inside of the ring will help you to achieve an aim for
positioning. Try doing this a couple of times before permanent attachment. Once you
are ready simply peel the red release liner from the back of the ring and then carefully
and slowly position the ring pressing firmly along the entire shape to set.
IMPORTANT NOTE: The top thicker portion of the trim ring will NOT attach to the paint
along the bottom of this section and need only be pressed along the top edge.
Once you have successfully installed the trim ring peel the top protective liner off.
5.
You have been supplied with a length 1/8” chrome trim. This trim has been supplied
to finish the edge of your new trim ring. To install it apply a thin bead of adhesive
promoter (provided) along the outer edge of the trim ring directly to the paint (this will
not harm your paint). Peel a small length of the red release liner from the back of the
chrome trim and start at the very bottom center on the trim ring, set the trim and press
it along the edge of the ring directly to the paint as you pull the liner until you reach the
start point. Snip away the excess trim and set the end into a nice tight butt seam.
TECH TIP: This trim will have a tendency to shrink over time, to compensate for this
place a small drop on instant adhesive (not included) to the end of the trim before you
set the butt seam. NOTE: Doing this will prevent a gap from forming over time.
If you have any questions during installation please call American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 | Fax: 727 861-1520