American Car Craft Corvette Plenum Cover Low Profile Perforated 1997-2004 C5 & Z06 User Manual
Page 2
the valve and then install the round bezel over the remaining end to completely cover the valve.
This will nicely trim the valve in chrome, see picture #4.
TECH TIP: Before placing the end bezel apply a small dab of instant adhesive to the two chrome
halves to bond them to each other this will help keep them in place long term. Allow some time for
the adhesives to set.
Your new cover has 2 Velcro strips of attachment tape on its underside. Remove the one side from
both strips and set aside for a moment. Place your new cover on top of the factory fuel rail covers
and line up so that it appears nice and straight and tucked under the back gasket ridge.
The next step is to place a length of masking tape on either side of the new plenum cover directly
onto both factory fuel rail covers. By doing this will indicate where the new cover will sit.
Next apply the Velcro hook strips along the inside edge about 1/4 inch inside of the tape edge you
just placed and press firmly to set. Remove the masking tape.
Now you can install the new cover by simply pressing into position. It may be necessary to slightly
lift and nudge the new cover in order to achieve a nice straight fit.
INSTALLATION TIP: Although this procedure should not be necessary with a clean and proper
installation you may apply 2 or 3 rivets thru the Velcro into your factory fuel rails on both sides to
insure that the Velcro stays in place.
Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust your cover with a clean
soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean micro fiber
cloth) with a good quality streak free foamy glass cleaner.
If any questions occur during installation, please contact American Car Craft at 727 861-1500.
Thank you and enjoy your new purchase.
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520