American Car Craft Challenger 5.7L and 6.1L SRT 8 Firewall Extensions with Hood Pin Switch Brushed 2pc 2008-2011 User Manual
Page 2
1. Your Challenger may contain a factory mounted cover attached to the passenger side of the
wiper cowl area. This plastic cover will have to be removed and will not be reused for this
application.
2. Place each of the two extensions in position and adjust their shape so that they contour to
the cowl area as well as the mounted firewall. This can be done by gently forming the panels
with your fingers until they match their placement.
3. Once they have been nicely formed you will notice that the two holes in each panel will line
up with the factory bolt heads. Mark this exact spot with a silver marker to confirm their exact
location on the bolt head then remove the two panels. Using the small double ended cobalt
drill bit provided drill a pilot hole a little over a 1/4 '' down into the bolt head and blow away
the shavings. This will create an exact mounting hole location for the two panels. Once this is
done simply place the panels back into position and then secure them with the 3/8” #8 pan
head screws provided. Place each of the screws through the white nylon socket and snug
them down. Once this is done simply snap the chrome decorative cover over the four screws.
Remove the protective liner to finish the installation.
If you have any questions during installation please call American Car Craft at 727 861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520