Peterson StroboPlus HD Metronome Manual - Manual (Page 6)

Note: When using the StroboPlus with the Vibe Clip as a tactile, pulsating metronome, the voice parts
are instead felt as levels of intensity. High, medium and low intensity vibrations correspond to the high,
medium and low pitches within the voices.
Using the StroboPlus with the Vibe Clip
The StroboPlus can be used as a tactile, pulsating metronome with the help of the optional Vibe Clip. The built-
in speaker and headphone output will automatically be silenced when a Vibe Clip is plugged into its designated
jack. The Vibe Clip allows the rhythm to be transmitted from the StroboPlus to the user invisibly and silently
via vibration. The Vibe Clip can be purchased from the Peterson Online Store.
https://www.petersontuners.com/index.cfm?category=135&action=itemView&itemID=40
Apply the Vibe Clip to one of the following areas:
1. Waist area along the belt-line.
2. Hip area near the pelvic bone
3. Nape of the neck
4. Shoe top or ankle area
5. Sleeve or pocket
Note: Be sure that the correct (capsule) side of the Vibe Clip is facing the body. If the vibration is
too intense, turn the capsule away from the body
.
Presets
Creating a New Preset
When your StroboPlus displays a combination of settings that you wish to save as a preset, press and hold the
Preset/Store button until the word “Preset”, a number, and the word ADD or SAV (“save”) appear. If other
presets have already been saved and you wish to create an additional one, turn the encoder knob until the word
“ADD” instead of “SAV” is shown. This will also display a preset number that has not already been used. Press
the Preset/ Store button again momentarily to confirm. The display will briefly show a circular animation to
indicate that your StroboPlus is saving your preset. If "ADD" does not show, you have entered the maximum
number of presets.
Overwriting an Existing Preset
To store the displayed combination of settings by overwriting the values already assigned to a particular preset
number, press and hold the Preset/Store button for two seconds. Rotate the Select Knob until the preset number
you wish to edit is displayed, along with the abbreviated word “SAV”. Press the Preset/ Store button
momentarily. A circular animation indicates that your values are saved to that preset number.
Deleting an Existing Preset
To delete a preset that was previously created, momentarily press the Preset/ Store button. Rotate the Select
Knob to display the preset number that you wish to delete, then press and hold the Select Knob for a few
seconds. The abbreviated word “DEL” will appear for a few seconds; continue to press the knob until you see a
circular animation. The "DEL" will then disappear which will indicate that the preset was deleted. All higher-
numbered preset combinations will have now shifted to a lower preset number accordingly.
Recalling a Preset for Use
To use a combination of settings that was previously saved as a preset on your StroboPlus, momentarily press
the Preset/ Store button. Turn the Select Knob to display the preset number you wish to recall. A moment after
you stop turning the Select Knob, the display will change from the preset number to the values associated with
that preset. To begin using those values, simply wait a few seconds without turning or pressing the Select Knob,
or to immediately accept the displayed values momentarily press the Power Button once.