Peerless-AV HCC101 - Installation - Manual (Page 2)

2 2012-09-20 #:009-9075-2 (2013-03-11)
ENG - Do not begin to install your Peerless product until you have read and understood the instructions and
warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions
or warnings, for US customers please call Peerless customer care at 1-800-865-2112, for all international
customers, please contact your local distributor.
• This product should only be installed by someone of good mechanical aptitude, and fully understands
these instructions.
• Never exceed the Maximum Load Capacity on page 1.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their
holding power.
• The cart is not affi xed or secured to the fl oor, and may therefore tip over and/or fall if display and/or stand
is shaken or hit. Always monitor children and do not let children play alone around stand as they could get
hurt by a falling display. Not recommended for use in areas with heavy traffi c.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and
personal injury.
Recommended cleaning steps
• The following procedures are not guaranteed to control infection. The hospital infection control administra-
tor or epidemiologist should be consulted regarding cleaning procedures and processes.
• To avoid risk of electric shock, do not expose electrical components to water, cleaning solutions or other
potentially corrosive liquids or substances.
• Do not immerse cart or cart components in liquid or allow liquids to fl ow into the cart. Wipe all cleaners off
surface immediately using a damp cloth. Thoroughly dry surface after cleaning.
• Do not use fl ammable cleaners on cart surfaces due to close proximity of electrical power and equipment.
• All paints and plastic cart components will withstand cleaning by most commonly used, diluted, non-
abrasive solutions such as quaternary ammonia compounds, ammonia enzyme cleaners, bleach or alcohol
solutions.
• Pen and permanent and dry erase markers can be removed with 91% isopropyl alcohol and a soft cloth.
• Iodine stains can be removed with commonly used cleaners and a soft cloth.
• Never use steel wool or other abrasive materials that will damage the surface fi nish.
• Do not use strong solvents such as trichloroethylene and acetone. These solvents will damage the
surface fi nish.
• It is recommended that any cleaning solution be tested on a small, inconspicuous area to ensure surface is
not harmed.
WARNING