Sena Bluetooth SPH10 v4.2 User's Guide - Manual (Page 18)

19
SPH10
English
However, even when this feature is enabled, if you
terminate intercom conversation manually with the
Jog Dial, you are not able to start intercom by voice
temporarily. In this case, you have to tap the Jog Dial
to restart the intercom. This is to prevent repeated
unintentional intercom connections by strong wind
noise. If you tap the Jog Dial to start an intercom
conversation, it is not terminated by 20 seconds of
silence. After turning SPH10 off and on, you can start
intercom by voice again.
9.3 Enabling/Disabling Voice Prompts
Voice Prompt “Voice prompt”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
You can disable voice prompts by configuration
setting, but the following voice prompts are always
on.
- Voice prompts for configuration setting menu
- Voice prompts for battery level Indicator
- Voice prompts for factory reset
9.4 Delete all Bluetooth Pairing Information
Voice Prompt “Delete all pairings”
Factory Default N/A
Execute Tap the Phone Button
To delete all Bluetooth pairing information of the
SPH10, rotate the Jog Dial until you hear a voice
prompt, “Delete all pairings”, and tap the Phone
Button to confirm. Taping the Jog Dial is not available
for this setting.
9.5 Exit Voice Configuration Menu
Voice Prompt “Exit configuration”
Factory Default N/A
Enable Tap the Phone Button
To exit voice configuration menu and get back to
stand-by mode, rotate the Jog Dial until you hear
a voice prompt,
“Exit configuration”, and tap the
Phone Button to confirm. Tapping the Jog Dial is not
available for this setting.