Zanussi ZDI11002WA - Manual (Page 22)

3
To remove filters (B) and
(C), turn the handle coun-
terclockwise and remove.
Pull apart filter (B) and
(C). Wash the filters with
water.
A
4
Remove filter (A). Wash
the filter with water.
D
A
5
Put filter (A) to its initial
position. Make sure that it
assembles correctly under
the two guides (D).
6
Assemble filters (B) and
(C). Put them into position
in filter (A). Turn the han-
dle clockwise until it
locks.
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove remain-
ing parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive prod-
ucts, abrasive cleaning pads or solvents.
Troubleshooting
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the Service.
With some problems, some indicators flash continuously
and/or intermittently at the same time to show an alarm
code.
Alarm code Problem
• The start indicator flashes continuously.
• The end indicator flashes 1 time intermittently. The appliance does not fill with water.
• The start indicator flashes continuously.
• The end indicator flashes 2 times intermittently. The appliance does not drain the water.
• The start indicator flashes continuously.
• The end indicator flashes 3 times intermittently. The anti-flood device is on.
22