MAX Power COMPACT - Manual (Page 13)

English Manual: Compact Retract 12/24V, Version 2 14/04/2005
B. Automatic Set-up Mode:
B.1 First go into Manual Mode following the procedure as described in section A above.
B.2 With system now in Manual Mode, push and hold down “On /Off”, “Up” and “Down”
pushbuttons simultaneously for a period of 3 seconds. The system will now go into Automatic
Set-Up Mode with “On” LED on and “Up” and “Down” LED’s flashing .
B.3 With the system in Automatic Set-up Mode the thruster will automatically lower, find it’s fully
down position, then raise, find its fully up position and switch off automatically.
B.4 The system can now be switched “On”, as shown in above drawing, and will be ready to use in
Normal Operation Mode .
C. Installation Mode:
C.1 First go into Manual Mode following the procedure as described in section A above.
C.2 Push and hold down “Up” pushbutton until unit double beeps, indicating that thruster is fully
up.
C.3 With system now in Manual Mode and fully up , push and hold down “On / Off”, “Up” and
“Down” pushbuttons, while pushing joystick to the right, simultaneously for a period of 3
seconds. The system will now go into
Installation Mode with alternate flashing of “On”, “Up”
and “Down” LED’s .
C.4 With the system in Installation Mode the thruster will automatically lower, find it’s fully down
position, then raise and stop some distance from the fully up position and switch off
automatically.
C.5 The hull closing plate should now be fixed into place, as described in Section 3.6.
C.6 Once finished with fixing of hull closing plate the thruster will be ready for final set-up
procedure.
C.7 For final set-up of thruster go into Automatic Set-up Mode , as described in section B, to allow
system to do its final set-up. System will now be ready to be used in Normal Operation Mode
(see sec ion D). t
D. Normal Operation Mode:
D.1 Switching the system “On” or “Off”:
a) To switch the thruster "ON" or "OFF" follow the instructions on the diagram above.
b) When switched "ON" the unit will double beep and the “On” and “Up” LED’s will light up.
c) When switched "OFF" the unit will double beep and all LED’s will go out.
d) It’s only possible to switch off the unit with thruster in the fully up position.
D.2 “Lowering” & “Raising” Thruster Unit:
a) Once unit has been switched on as described above, press and hold the “Down” pushbutton for
one second after which unit will beep once and then lower automatically to fully down position.
b) When thruster will be fully down the “Down” LED comes on and the buzzer double beeps to
indicate that thruster is completely down and ready to thrust.
13
c) As long as thruster is in the down position the buzzer will beep (short) once every three seconds,
to indicate that thruster is still in the down position.