R&M Materials Handling HOIST MONITORS - Manual (Page 13)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
13/105
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
3.3.2 Menu Mode
Pushing the ENT button in the tare or actual load display mode, shifts the display into the menu mode. A
password is required in order to proceed. Pushing the ESC button returns to the actual load display.
3.3.3 Status mode
Status mode indicates all active faults, warnings and service warnings when applicable. The display
shifts automatically into the status mode when a fault or warning occurs during power ON. If more than
one fault or warning are active, all of them can be seen with arrow keys; active faults first, then warnings
and service warnings. The active fault message remains visible until the fault disappears, or the message
is removed by pushing the ENT button.
Display Description
Fault
Fault name
Status display indicating active faults status.
Warning
Warning name
Status display indicating active warnings status.
Service
Service name
Status display indicating active service status.
3.3.4 Sum load / solo hoist load mode
In multi-hoist applications, the display shows the summed tare load as the first display at power on.
Toggling between the tared sum load, the actual sum load and the actual load of each connected hoist
individually is done with the up and down buttons.