Installation instructions (continued) – S&B Filters Cold Air Intake Kit - Cotton Filter 75-5057 User Manual
Page 2
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
INSTALLATION INSTRUCTIONS (continued)
10.
Place the Silicone adapter
(B)
and both
#64 Hose Clamps
(A)
onto the Intake tube
(C)
as shown. Tighten the clamp on the intake
tube so that the screw can be accessed for
future tightness checks.
14.
Slide the 2 #72 Hose clamps
(H)
over
the Hump Adapter
(G)
. Then push the Hump
adapter
(G)
over the Adapter tube
(K)
. Leave
clamps loose for now.
19.
Install the Intake tube assembly by
sliding the breather hose over the steel tube
on the truck. Then push the silicone adapter
over the turbo inlet. Leave loose for now.
11.
Slide the Breather hose over the spout
on the Intake tube
(C)
. Slide both #12 Hose
clamps
(X)
over the hose and tighten the
clamp on the spout.
15.
For those concerned about minimal
engine heat; install the Box Plug
(V)
into
the bottom of the Air Box
(Q)
using the
1/4-20 hardware. For those seeking
additional air flow, set the Box Plug aside.
12.
Place the Adapter tube
(K)
into the
base of the S&B Air Filter
(J)
and tighten the
#88 Hose clamp.
16.
Install the Air Box
(Q)
into the truck. Be
sure both prongs on the bottom of the air box
push into the two grommets on the side of
battery tray.
20.
Make sure the Intake tube
(C)
and
Adapter tube
(K)
are aligned up top and
tighten the hose clamp at the turbo
connection. Also tighten the hose clamp at
the crankcase breather connection.
13.
Use the remaining 8-32 SS Screw
(F)
and IAT Sensor Gasket
(D)
, and install the
IAT sensor into Adapter Tube
(K)
.
17.
Attach the Air Box
(Q)
using the
supplied M8x1.25x40mm Allen Head screw
(R)
.
21.
Slide the Hump Adapter
(G)
over the
Intake tube
(C)
and secure both the #72 Hose
Clamps
(H)
.
SEE EXPLODED VIEW ON PAGE 4
2
P/N: 75-5057 / 75-5057D
18.
Carefully place the filter assembly into
the Air Box trying not to ding or gouge the
wire mesh. Rotate the Filter Adapter
assembly into position and hook the clip into
the Air Box.
(See page 3 for more info)