Braun Z40 CruZer2 - Manual (Page 5)

6
English
Our products are designed to meet the highest standards of
quality, functionality and design. We hope you entirely enjoy
your new Braun shaver.
Warning
Your shaver is provided with a special cord set with an
integrated Safety Extra Low Voltage power supply. Do not
exchange or manipulate any part of it. Otherwise there is risk
of electric shock.
This appliance is not intended for use by children or persons
with reduced physical, sensory or mental capabilities, unless
they are given supervision by a person responsible for their
safety. In general, we recommend that you keep the appli-
ance out of reach of children.
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Rotating styler
4a Wide shaper (28 mm)
4b Narrow shaper (14 mm)
5 Charging
light
6 On/off switch
7 Special cord set
Charging
The best environmental temperature for charging is between
15 °C and 35 °C. Do not expose the shaver to temperatures
higher than 50 °C for extended periods of time.
Using the special cord set, connect the shaver to an
electrical outlet with the motor switched off.
When charging for the first time, leave the shaver to
charge continuously for 4 hours. The green charging light
(5) shows that the shaver is being charged. When the
battery is fully charged, the charging light intermittently
blinks on and off. This indicates that the battery maintains
its full capacity.
A full charge provides 30 minutes of cordless shaving time
depending on your beard growth.
Once the shaver is completely charged, discharge the
shaver through normal use. Then recharge to full capacity.
Subsequent charges will take about 1 hour.
Maximum battery capacity will only be reached after
several charging/discharging cycles. •
•
•
•
•
99305114_Cruzer Z40.indd 6 99305114_Cruzer Z40.indd 6 18.08.2009 8:26:24 Uhr 18.08.2009 8:26:24 Uhr