Braun Z40 CruZer2 - Manual (Page 6)

7
If the rechargeable batteries are discharged, you may also
shave by connecting the shaver to an electrical outlet via
the special cord set.
Shaving
Remove the foil protection cap (1). Activate the on/off switch
(6). The floating foil frame automatically adapts to your skin
surface for a close, smooth shave.
For best results:
Always shave before washing your face.
At all times, hold the shaver at right angles (90°) to the
skin (b).
Stretch the skin and shave against the direction of hair
growth.
For pre-shaving after a few days of not having shaved, use
the wide shaper (4a) to pre-cut long hairs. For a close,
smooth shave, finish with the foil.
To maintain 100% shaving performance, replace your foil
and cutter block at least every 18 months or when worn.
Using the rotating styler (4)
The wide shaper (4a) evenly cuts and trims large areas.
It is ideal for shaping sideburns, moustaches and partial
short beards. The wide shaper is provided with safety rips
and a gliding strip for less irritation and easy gliding.
Press the green stripes (c) to push up the rotating styler (4).
While stretching the skin, guide the wide shaper against the
direction of hair growth.
The narrow shaper (4b) precisely defines lines and edges (d),
being ideal for precise contouring.
To use the narrow shaper, push up the styler and turn it 180°.
Frequent use of the styler (4) will reduce the battery capacity.
Cleaning
This appliance is suitable for cleaning under an open
water tap.
Warning: Detach the hand-held part from the power
supply before cleaning it in water.
Regular cleaning ensures better shaving performance.
Rinsing the shaving head after each shave under running
water is an easy and fast way to keep it clean:
Switch the shaver on (cordless) and rinse the shaving head
under hot running water (e). A natural based soap may
•
•
•
•
•
•
•
99305114_Cruzer Z40.indd 7 99305114_Cruzer Z40.indd 7 18.08.2009 8:26:25 Uhr 18.08.2009 8:26:25 Uhr