4 installation, 1 prepare the iq–p.i.p.–smt – Crown Audio IQ-P.I.P.-SMT User Manual
Page 18
Page 18
IQ P.I.P.–SMT
4 Installation
Before beginning, please carefully
note:
CAUTION: ST
CAUTION: ST
CAUTION: ST
CAUTION: ST
CAUTION: STA
A
A
A
ATIC ELECTRICITY
TIC ELECTRICITY
TIC ELECTRICITY
TIC ELECTRICITY
TIC ELECTRICITY
MA
MA
MA
MA
MAY DAMAGE THE
Y DAMAGE THE
Y DAMAGE THE
Y DAMAGE THE
Y DAMAGE THE
IQ–P
IQ–P
IQ–P
IQ–P
IQ–P.I.P
.I.P
.I.P
.I.P
.I.P.....–SMT
–SMT
–SMT
–SMT
–SMT
MODULE.
MODULE.
MODULE.
MODULE.
MODULE. Use caution when han-
dling the unit. Carefully ground your-
self
BEFORE touching the
IQ–P.I.P.–SMT module. For added
safety, touch the outer metal collar of
either Crown Bus connector (see Fig-
ure 2.1). This should safely discharge
any static electricity through the
ground plane of the module. Avoid
unnecessarily touching the compo-
nents, edge connector or solder
pads on the circuit boards.
NOTE — Amplifier Compatibility
The version of the
IQ-P.I.P.-SMT card
you received will vary depending on
whether you indicated the card will
be installed on a PIP2-compatible
amplifier (such as the Crown
MA-
5000VZ or CT-10 Series amplifiers).
The correct card to install in a PIP2-
compatible amplifier is the
IQ-P.I.P.-
SMT-PIP2. The standard IQ-P.I.P.-
SMT should be ordered for non-PIP2-
compatible amplifiers.
Should you later wish to change the
amplifier you are using for your
IQ-
P.I.P.-SMT installation, it is possible to
alter the card's configuration by sim-
ply removing or installing two SIPS
from the card's circuit boards
1
. For in-
structions on installing or removing
these SIPS, contact Crown Technical
Support.
4.1 Prepare the
IQ–P.I.P.–SMT
1.
Set the IQ address switch
SW1.
By giving each IQ com-
ponent a unique address, it
can be individually controlled
and monitored. Whenever the
IQ System wants to send a
command to just one IQ com-
ponent, it first sends its ad-
dress and then the command
down the Crown Bus.
The 8-segment DIP switch
(SW1) shown above is used
1
IQ-P.I.P.-SMT-PIP2 has SIPS installed; IQ-P.I.P.-SMT has SIPS removed.
Fig. 4.1 IQ Address Switch (SW1) Location