Anchor Audio AN-130+ Speaker Monitor - Manual (Page 7)

MADE IN USA
SIX YEAR WARRANTY
AN-130+ Speaker Monitor Owners Manual
AN-130+ TECHNICAL SPECIFICATIONS
(Specifications Subject to Change Without Notice)
Anchor Audio customer service
800.262.4671
For AdditionAL inFormAtion
visit www.anchoraudio.com
7
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
CONDITION POSSIBLE CAUSE
No Sound (Power LED Not Lit) • turn POWER switch on
• plug in power cord
No Sound (Power LED Lights) • check for output from source
• make sure all cables are completely plugged in
• increase volume control
• press mute button on remote (AN-130+RC only)
• turn power switch to off then back to on (AN-130+RC only)
Distorted Sound • check input cable connection
• lower input signal level
Excessive Hum or Noise • use shielded input cables
HAVING TROUBLE WITH YOUR WIRELESS SYSTEM? (Wireless Model Only)
No Sound • confirm transmitter power switch is set to on
• turn up volume control
• plug microphone into body-pack transmitter
• turn sound system on
• replace mic/transmitter battery
• make sure hands free mic cable is fully plugged into transmitter
• turn off mute by pressing, volume up/down or mute (AN-130+RC only)
Frequent Transmitter Dropouts • replace mic/transmitter battery
• move mic/transmitter closer to AN-130+
• change transmitter to different channel
Rated Power Output 30 watts
Max SPL @ Rated Power 103 dB @ 1 meter
Frequency Response
65 Hz – 18 kHz ± 3 dB
Speaker Type 4.5” woofer, 10 mm dome tweeter
AC Power Reqs. 110 – 125 VAC, 50/60 Hz
Export Model 208 – 240 VAC, 50/60 Hz
(50W max)
Fuse Rating T 1.0A / 250V
Export Model T 0.5A / 250V (internally mounted)
Dimensions (HWD) 5.25” x 8.4” x 9”
(13 x 21 x 23 cm)
Weight 8.5 lbs / 3.8 Kg
Inputs
Line
Hi-Z, unbalanced, 1/4” & 1/8” jack
Microphone Lo-Z, unbalanced, 1/4” jack
Output
Line
Lo-Z, buffered, 1/4” phone
Sensitivity For Rated Output
Line
-20 dBV (100 mVrms)
Microphone -43 dBV (7.5 mVrms)