Anchor Audio AN-135+ Speaker Monitor - Manual (Page 4)

MADE IN USA
SIX YEAR WARRANTY
AN-135+ Speaker Monitor Owners Manual
AN-135+ TEChNICAL SPECIFICATIONS
(Specifications Subject to Change Without Notice)
Anchor Audio customer service
800.262.4671
For AdditionAL inFormAtion
visit www.anchoraudio.com
4
Rated Power Output 30 Watts
Max SPL @ Rated Power 103 dB @ 1 meter
Frequency Response 65Hz - 18KHz ±3dB
Speaker Type 4.5” Neodymium woofer
Line Out Jack line level, 3.5 mm – stereo
Line In Jack line level, 3.5 mm – stereo & 1/4” phone – mono
AC Power Req. 100 - 240 VAC, 47/63 Hz (70W Max.)
Dimensions (HWD) 5.25” x 8.4” x 9” (13 x 21 x 23 cm)
Weight 3.5 lbs / 1.58 Kg
hAVING TROUBLE WITh YOUR SOUND SYSTEM?
CONDITION POSSIBLE SOLUTION
No Sound (power LED off) • turn POWER switch ON
• charge battery or plug in AC cord
Charge Indicator LED off • leave plugged in for 48 hours to repair battery
No Sound (power LED on) • check for output from source
• set Internal Speaker switch to ON
• make sure all cables are completely plugged in
• turn up volume control of input used
• remove plug from speaker output if not using external speaker
output
Shortened Battery Life • charge battery fully; if battery life continues to deteriorate,
contact Anchor Audio customer service: (800) 262-4671
Distorted Sound • lower system volume control
Excessive Hum or Noise • use shielded cables
• use balanced microphone
hAVING TROUBLE WITh YOUR WIRELESS SYSTEM? (WIRELESS MODELS ONLY)
CONDITION POSSIBLE SOLUTION
No Sound (RX Indicator: ON) • set MUTE switch to on (handheld mic only)
• turn up WIRELESS volume control
• make sure mic is plugged into body pack transmitter
No Sound (RX Indicator: OFF) • push mic power button
• turn AN-135+ POWER switch on
• make sure transmitter power switch is on
• set receiver and transmitter to same channel
• replace battery in transmitter
NEED MORE HELP? AN-135+ Speaker Monitor Setup & Operation Videos!
Visit Our Website: www.anchoraudio.com