PolyPlanar RD44 - Manual (Page 5)

1352 Charwood Road • Suite D • Hanover, MD 21076 • Tel (410) 761-4000
www.polyplanar.com
5
The RD44 can be mounted in a
panel using the supplied “U” bracket and stainless steel stud assembly.
Insert the supplied stud into the threaded rear housing. Use one of the
5mm nuts to lock the stud in place.
Find a suitable location with enough depth and access for the DIN
network connecting cable and hand access to tighten the nut.
Use the template provided to drill 2 holes: 2⅛ (54mm) for the main body
and 3/16 (5mm) for the locating pin. Insert the RD44 and use the bracket
and nut to secure the Display. Do not over tighten the nut.
The “U” bracket has break off sections that can be removed for thick
panels.
The RD-44 can also be mounted using the supplied back cover and
bracket. The bracket can be installed for dash or overhead mount.
Make sure that there is adequate clearance and a good viewing angle
for the display. Also, consider the routing of the network cable.
Use the bracket to mark the position of the fastener holes.
Panel Mounting
Break off as needed
(Network connection cable not shown for clarity)
Bracket Mount
Panel Mounting