AEG SV5028 - Manual (Page 10)

10 Daily use
Important!
• Do not fill too much into the drum.
• Do not exceed the laundry capacity
specified for the product.
• Leave around 3 cm of free space
between the retainer disc and the
upper rim of the drum.
1. Put an adequately large water
collecting bowl (not supplied)
under the exhaust nozzle.
2. Insert the plug into the socket outlet.
3. Close the lid and move the lever to
the “I” – ON position.
The spin dryer will begin to run and
the water will flow through the
exhaust nozzle.
An initial loss of balance or oscillation is normal. The spin dryer will tend to
stabilize after operating for some seconds.
Important!
Constantly check the coming out of water into the collecting bowl located under
the exhaust nozzle. If the bowl gets full:
1. Move the lever to OFF position.
2. Empty the water collecting bowl.
3. Relocate the water collecting bowl under the exhaust nozzle.
4. Restart the spin drying cycle by moving the lever to ON position.
Turning the spin dryer on