AEG SV5028 - Manual (Page 15)

Installation 15
Installation instructions
Installation
• Remove all packaging, external and internal, before positioning the spin dryer.
• Place the appliance only on flat, dry, heat resistant floors, which do not get
damaged with humidity or water. Do not place the spin dryer on delicate
floors or parquets.
• Place the spin dryer at a suitable distance away from walls or other objects.
Electrical connection
Warning!
The spin dryer requires that the electrical installation of the building where the
appliance is to be installed, be provided of earth connection.
if you have doubts about this subject, make check your electric circuit by an
authorized electric technician.
Under no circumstances connect your spin dryer if your electric circuit is
not provided with earth connection. There is risk for the user.
• Prior to using the appliance for the first time, ensure that the rated voltage
and type of supply on the rating plate match that of the supply where the
appliance is to be connected.
Warning!
Always connect the plug into a correctly installed shockproof socket.
Multi-way plugs, connectors and extension cables must not be used.
This could constitute a fire hazard through overheating.
• The plug must be accessible after the spin dryer has been installed.
• Never unplug the spin dryer by pulling on the mains cable. Always pull the plug.
• Do not use the spin dryer if the mains cable is damaged.
In case of any damages, contact your local authorized service centre for
checking it and to avoid any hazard.
• The manufacturer accepts no liability for failure to observe the above safety
precautions.