QTECH SmartEdge 100 PPP and PPPoE - Manual (Page 14)

Configuring PPP and PPPoE
subscriber name to determine whether to create a new MLPPP bundle or
add the session to a current MLPPP bundle.
You can use MLPPP using PPPoE with the following types of Ethernet
encapsulation:
0 Ethernet with untagged traffic
0 802.1Q PVCs
0 802.1Q tunnels
The system does not allow MLPPP using PPPoE over ATM (PPPoEoA).
To use this form of MLPPP, you must use ports configured on a GE traffic
card that has a PPA2; these traffic cards include the GE3, GE1020, and
10GE traffic cards. The configuration for this form of MLPPP is described
later in this document in the document, Section 3.2.9 on page 20.
4 MLPPP using PPP-encapsulated DS-1 channels and E1 channels and ports
Using this form of MLPPP, you create a static MLPPP bundle and add
specific DS-1 channels, E1 channels, or E1 ports to it.
Note: For information about configuring this type of MLPPP and the
constituent channels or ports, see the document, Configuring
MLPPP.
10 64/1543-CRA 119 1170/1 Uen K | 2012-12-04