QTECH SmartEdge 100 PPP and PPPoE - Manual (Page 3)

Contents
Contents
1 Overview 1
1.1 PPP-Encapsulated Circuits and Binding 1
1.2 PPP Oversubscription 3
1.3 Single-Stack and Dual-Stack Support 3
1.4 PPP Keepalive Checks 4
1.5 PPPoE Features 6
1.6 Using IPCP Option 144 to Reserve IP Addresses and
Install Subnet Routes
6
2 Multilink PPP 9
3 Configuration Tasks 11
3.1 Configuring PPP 11
3.1.1 Configure PPP Global Attributes 11
3.1.2 Configure a PPP-Encapsulated Port 12
3.1.3 Configure a PPP-Encapsulated ATM PVC 12
3.1.4 Configure a Subscriber Record for PPP 13
3.1.5 Configure an Interface for Static PPP Peer Router IP
Address Assignment
13
3.1.6 Configure MLPPP on ATM PVCs 13
3.1.7 Example: MLPPP Configuration on ATM PVCs 14
3.1.8 Configure MLPPP for L2TP Subscribers 14
3.1.9 Example: MLPPP Configuration for L2TP Subscribers 15
3.2 Configuring PPPoE 15
3.2.1 Configure PPPoE Global and 802.1Q Profile Attributes 15
3.2.2 Configure a PPPoE-Encapsulated Ethernet Port 16
3.2.3 Configure a PPPoE-Encapsulated ATM PVC 17
3.2.4 Configure a PPPoE-Encapsulated 802.1Q PVC 17
3.2.5 Configure a PPPoE-Encapsulated Child Circuit on an ATM
PVC
18
3.2.6 Configure a PPPoE-Encapsulated Child Circuit on an
802.1Q PVC
19
3.2.7 Configure a Subscriber Record for PPPoE 19
3.2.8 Configure IPCP Netmask Negotiation 20
3.2.9 Configure MLPPP over PPPoE 20
3.2.10 Example: MLPPP Configuration on PPPoE 21
4 Operations Tasks 23
5 Configuration Examples 25
5.1 PPP Examples 25
5.1.1 PPP Configuration with Dynamic Binding 25
64/1543-CRA 119 1170/1 Uen K | 2012-12-04