Buyers 1503005 - Manual (Page 4)

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
11. Repeat on opposite side.
12. Install Cross Bar with Clamp in the front of the
rack by inserting Crossbar end and telescoping tubes
until they are extended to secure to side rails. Secure
the Cross Bar end with a clamp and 4 Carriage Bolts,
4 lock washers, 4 flat washers and 4 nuts. 13. Secure the opposite end to side rail in the same fashion.
14. Locate weld nut on the Cross Bar with Clamp, and
insert a set bolt into weld nut to set bar length and
stabilize rack.
15. Insert remaining set bolts into any vacant welded nuts.
16. BE SURE TO TIGHTEN EVERY ASSEMBLY WITH
A 9/16” WRENCH TO ENSURE RACK IS SECURED.
17. PERIODICALLY CHECK ALL HARDWARE FOR
TIGHTNESS.
18. WE RECOMMEND CAULKING GAPS WHERE TUBES
TELESCOPE WITH A CLEAR SILICONE TO ELIMINATE
WIND NOISE AND PROLONG THE APPEARANCE OF
YOUR RACK.
19. AS WITH ANY RACK WHICH EXTENDS OVER
PASSENGER DOORS, EXERCISE CAUTION WHEN
ENTERING & EXITING VEHICLE TO AVOID
HEAD INJURIES.
Warranty Information
Buyers Products warrants all truck/trailer hardware manufactured or distributed by it, to be free from
defects in material and workmanship for a period of one year from date of shipment. Parts must be properly
installed and used under normal conditions. Any product which has been altered, including modification,
misuse, accident or lack of maintenance will not be considered under warranty. Normal wear is excluded.
The sole responsibility of Buyers products under this warranty is limited to repairing or replacing any part
or parts which are returned, prepaid, and are found to be defective by Buyers Products. Authorization from
Buyers Products must be obtained before returning any part. No charges for transportation or labor per-
formed on Buyers’ products will be allowed under this warranty.
Part No. 3006398 5HY%
11
12
a
12
b