SENA HD1300 User Manual
Page 26
Starter Kit and User Manual for the HelloDevice 1300
26
5.2.1. Configure serial communication parameter of the HelloDevice
the HelloDevice Utility software provides a function to configure serial communication parameter of the
HelloDevice serial port to make the parameter as same as that of user device. You can perform this configuration
by using the function of [Sys Set-up] window of Utility software.
Take following steps to configure the parameters.
1) Select [Serial] item from [Device] selection combo box.
2) Set the proper item from parameter combo box.
§ baud rate
One of 150, 300, 600, 900, 1200, 2000, 2400, 3600, 4800, 7200, 9600, 19200, 38400
§ parity
One of None, Even, Odd
§ Data bits
One of 5, 6, 7, 8 bits
§ Stop bits
One of 1, 1 ½ , 2 bit
§ handshake
One of None, H/W, X On/Off
Let’s say that IP address of the HelloDevice is 192.168.1.15, and the serial communication parameters are 9600
baud rate, Parity None, Data bit 8, Stop bit 1 and Handshake None.