SENA HD1300 - Manual (Page 27)

Starter Kit and User Manual for the HelloDevice 1300
27
Figure 5.9 Serial parameter input window
3) Press [Send] button and these parameters will be sent to the HelloDevice via network. the HelloDevice
will set its serial communication parameter as such.
5.2.2 Hook up your PC and the HelloDevice for demo
Take following steps to properly hook up the demo components.
1) Prepare a PC connected to network.
2) Hook up RS232 cable between the RS232 port of your PC and that of the HelloDevice. You can refer to the
cable specification at chapter 3.
3) Run RS232 terminal emulator on your PC.
We will show this demo by using HyperTerminal program of your PC. Let’s say you are using COM1
port for serial communication demo.
4) Set the parameters of HyperTerminal program.
Set the parameters as same as those of the HelloDevice serial port, as you finished in chapter 5.2.1.