SENA HD132x Series - Manual (Page 14)

HD132x Series User Manual
14
4. Setting Up Your HelloDevice
The HelloDevice is installed in a following order:
1. Connect the HelloDevice to the power supply and Ethernet
2. Install the HelloDevice Utility Software on your PC
3. Assign an IP address of the HelloDevice
4. Set parameters of the HelloDevice
4.1 Connecting Hardware
4.1.1 Connecting HD1320 / 1320E
Since the hardware architecture of HD1320E and HD1320 is identical to each other, so is the setup
process. In this section, HD1320E is used as an example.
(1) Connect the 7.5V ~ 9V DC power supply adaptor to HD1320E.
7.5V DC Power
110/220 V
HD1320E
Figure 4.1 Power Connection to HD1320E
(2) Connect HD1320E to the Ethernet hub through RJ45. (Refer to Chapter 3 for details on RJ45
connector.)