SENA HD1100 - Manual (Page 17)

Starter Kit and User Manual for the HelloDevice 1100
14
verifies that the HelloDevice works successfully as a web server.
Figure 4.9 HelloDevice default Web page
4.3.2 Changing IP address
To change the IP address, initialize the IP address to the factory default value of 0.0.0.0, and repeat the
procedures of setting an IP address in section 4.3.1. At this point, ask your network administrator for a new IP
address. For example, let's try to change IP address of 192.168.1.15 to 192.168.1.18.
(1) Initializing IP address
Before you initialize IP address of HelloDevice, you have to remove IP/MAC address data stored in your PC.
This information is stored in ARP cache, and you can make sure what is stored in the cache by using the
following command. This is the response of the command in case that IP address of user PC is 192.168.1.100.
>>arp -a
Interface: 192.168.1.100 on Interface 2
Internet Address Physical Address Type
192.168.1.15 00-01-95-04-02-03 dynamic
192.168.1.23 01-a0-11-34-11-0d dynamic