SENA HelloDevice UniversalComm - Manual (Page 7)

7
3.4 UDP Server mode setting
1) Enter the UDP server port number into the Server Port field, and enable the UDP
Server/Client check box.
2) Press [ Bind ] button, and then the UDP Server session is created.
3.5 UDP Client mode setting
1) Enter the IP address and UDP port number of the remote host to connect into the field
Destination IP and Destination Port , and then, enable the UDP Server/
Client check box.
2) Press [ Bind ] button, and then UDP client session is created.
3.6 UDP tunneling mode setting
UDP tunneling mode is the one that only peer-to-peer data transfer is available under this mode.
The incoming data from the specified remote host is received only through Server port, and
outgoing data is transferred only to the specified host with specified IP address and the port
number.
1) Enter the UDP server port number into the Server Port field, and enter the IP
address and UDP port number of the remote host to connect into the field
Destination IP and Destination Port .