SENA Promi-SD 205 - Manual (Page 24)

Promi-SD User Manual – 2. Configurations 20
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
Click [Search] button to search nearby Bluetooth devices. The maximum number of devices to be searched can be
controlled. Select one of the devices searched and click [Connect] button. The selected Bluetooth device must be in
Page scan mode. Click [연결 해제] button to cancel the connection normally.
Connecti on(in) icon will show the following window to make Promi-SD wait to a connection from the other Bluetooth
device. The waiting time in seconds can be controlled. With 0 input for this waiting time, Promi -SD keeps waiting for
connection until [Cancel] button is clicked.
Terminal Program
A terminal program is an application that will enable a PC to communicate directly with a modem. If you are using
Windows 98SE or higher version of Windows, HyperTerminal program as it is included as part of the operating sy stem.
Promi -SD provides some extended AT commands for its configurations on terminal program.
This manual will explain the method using HyperTerminal. If you need to install HyperTerminal, click start>setting>control
panel>add/remove programs. For more precise information, please refer to Help of Microsoft Windows.
Attach Promi-SD to serial port of host computer and power on. Check Status LED (Promi -SD101/202) or Standby LED
(Promi -SD205) is lit in green.
Launch HyperTerminal. It can be found in start >programs >accessories >communication >HyperTerminal. Select the
Serial port that Promi -SD will be connected to.
Input the same settings into Serial port configuration window as Promi -SD settings.
The settings need to be set correctly, otherwise, error message may be shown up on the screen or cause
malfunctioning of Promi-SD.