17 atd, 19 ath – SENA Promi-SD 205 User Manual
Page 44
Promi-SD User Manual – Appendix A. AT Commands
A-8
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
Purpose
Wait for connection by the Bluetooth device with given BD address
Parameters
112233445566=BD address
to= time duration in seconds
Description
For the given to, Promi-SD is waiting for the connection from the Bluetooth device with
the given BD address. If the parameter of to is 0, it will wait forever.
When connection is made with the Bluetooth device, SD response will be ‘CONNECT’
with its BD address. If there is no connection made within this time duration, SD response
is ‘ERROR’ and the operation status becomes to ‘Standby’.
Reference
ATD, AT+BTINQ?, AT+BTCANCEL
Example
AT+BTSCAN000B530011FF,30
17
ATD
SD Response
OK
CONNECT 112233445566
or
OK
ERROR
Purpose
Connect to the last connected Bluetooth device
Description
Promi -SD saves the BD address of the Bluetooth device most recently connected. ATD
can make connection to it without input its BD address.
If it fails to make connection, SD response is ‘ERROR’.
Reference
AT+BTINQ?, AT+BTSCAN
18
ATD112233445566
SD Response
OK
CONNECT 112233445566
or
OK
ERROR
Purpose
Connect to the Bluetooth device with given BD address
Parameters
112233445566=BD address
Description
Promi -SD attempts to connect to the Bluetooth device with the given BD address. To
make successful connection, the Bluetooth device must be in Page scan. This attempt
continues for 5 minutes.
If it fails to make connection, SD response is ‘ERROR’.
Reference
AT+BTINQ?, AT+BTSCAN
Example
ATD000B530011FF
19
ATH
SD Response
OK
DISCONNECT
Purpose
Release the current connection
Description
The current Bluetooth connection is released normally. It takes about 30 seconds to
detect an abnormal disconnection such as power off and moving out of service range.
Reference
ATD, AT+BTSCAN