Aqua-Pure CBW1001 - Manual (Page 7)

1-3
Facts to Remember While Planning The Installation:
1) All installation procedures MUST conform to local and state plumbing codes.
2) If lawn sprinklers, a swimming pool, or geothermal heating/cooling or water for other devices/activities are to be treated by the system, a larger
model MUST be selected to accommodate the higher fl ow rate plus the backwashing requirements of the system. Consult your Dealer/Installer or
our Customer Service Department at 1-800-222-7880 for alternative instructions if the pumping rate is insuffi cient.
3) Remember that the system inlet is attached to the pipe that supplies water (i.e. delivers water from the well pump or after the water meter)
and the outlet is the line that runs toward the water heater.
CAUTION
To reduce the risk associated with property damage due to plugged water lines:
• Pay particular attention to correct orientation of control valve. Water fl ow should match arrow on control valve. The Inlet and Outlet of other water treatment
equipment products will vary depending on the control valve brand used.
4) Before beginning the installation review the existing piping system and to determine the size, number and type of fi ttings required.
WARNING
To reduce the risk associated with a hazardous voltage:
• If the home electrical system requires use of the cold water system as an electrical safety ground, a jumper must be used to ensure a suffi cient ground connec-
tion across the system installation piping — refer installation to qualifi ed personnel.
5) Sweep the fl oor to eliminate objects that could pierce the media tank.