Pro Series 51146 51 Receiver - Manual

Existing M12
Hex Washer Bolts
Both Sides
Frame
Bumper
Structure
Existing Weld Nuts
5 Places
Both Sides
Bumper Bracket
Both Sides
Figure 1
Hitch Shown In Proper Position
Frame Rail
Fascia
Installation Instructions
Toyota Tacoma
(Does Not Fit Toyota X-Runner)
Part Numbers:
51146
1. CAUTION: SUPPORT THE BUMPER STRUCTURE TO KEEP IT FROM SWINGING OUT OF POSITION DURING HITCH
INSTALLATION.
2. Referring to Figure 2, remove two (2) of the existing M12 hex washer bolts from the bumper bracket as shown, and loosen the
other three (3) bolts. Do this on both sides.
Rev. A 8-3-09 51146N Sheet 1 of 6 z 2009 Cequent Performance Products
Hex Bolt, M12 x 40 x 1.25 Qty. (4) 2
Spacer Qty. (4) 3 Conical Washer, 1/2” Qty. (4) 1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Equipment Required: Torque Wrench
Wrenches: 10mm, 17mm, 19mm
Drill Bits: NONE
Fastener Kit: 51146F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 (227 Kg.) 5000 (2270 Kg.)
Weight Carrying
Ball Mount
550 (250 Kg.) 5500 (2497 Kg.) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: PU3, PU4
Remove
Loosen
Figure 2
Remove