Procom GF RK-900 - Manual (Page 2)

4. ADHESION ADVICE
It is essential for a good adhesion result that the surfaces are properly
cleaned and dry.
A high application pressure improves the binding power.
Ideal application temperature range is +20° C to +38° C but may be
extended down to +15° C. When applied, binding strength is maintained
between -30° C and +70° C.
Binding power increases considerably with time. To ensure full strength
of the assembly it is recommended to keep the whip off the mount for
24 hours.
To accelerate attainment of full binding power, the joined parts may be
heat-treated with a warm-air gun.
PLEASE NOTE: Do not heat parts to more than 65° C and take care not
to spoil other nearby car parts.
WARNING SAFETY PRECAUTIONS
Antennas mounted on the windscreen may cause relatively high field
strengths in the passenger cabin and near the dashboard.
To prevent health hazard due to RF radiation, persons must not be 1.
closer than 30 cm to the antenna whip (transmitter output power to
the matching unit: 20 W). (DIN 57 848).
The RF signals at the dashboard may cause interference in the car’s
2.
electronic equipment such as broadcast radio, computer automatics,
braking systems, electronic ignition, relays etc. Some cars are more
susceptible to disturbances than others. It is the responsibility of the
installer to carry out a thorough check of the proper functioning
under any conditions of such circuits before finishing installation.
The enclosed silicone adhesive contains acetic acid and fungicides. Keep out
of reach of children and dispose properly.
PROCOM A/S reserve the right to amend specifications
without prior notice.
13/12/11