Procom MU 4-xg-... - Manual (Page 2)

INSTALLATION
The XG-antenna types can be mounted anywhere on the car, however, roof
top mounting is always recommended.
The oblong XG-mount can be mounted on the often very narrow strip on the
rear wing between the hatch and the side of the car.
Mounting can take place exclusively with access from the outside when
drilling an 18 mm dia. hole. Mounting can take place from the inside by
drilling a 14 mm dia. hole. When mounting in a 14 mm dia. hole, remove the
bottom plastic ring of the packing gasket with a sharp cutter.
When cleaning the car in car-washing machines, remove the whip using a
spanner, size 9 mm. After wash, refit the whip and tighten it lightly with the
spanner.
As the XG-mount is internally equipped with a bendable section, the antenna
can always be adjusted to an upright position independent of the tilt angle
of the installation spot.
1. INSTALLATION DIMENSIONS
2. INSTALLATION STEPS
Do not use sealer on rubber gasket or other places.
ASSEMBLY INSTRUCTIONS
Put GPS-FME-connector-cable through the gasket (2). 1.
Put the gasket (2) + GPS-part (1) over the body (B). 2.
Put the body (B) + gasket (3) + GPS-part (1) through the ø18 mm 3.
hole.
Put the housing (4) over the body (B) and be sure that the GPS-part
4.
(1) fits into the square hole in the body (B).
Put the threaded part over the body (B) and tighten max. 4 ±1 Nm!.
5.
Put the corrugated plastic unit (6) over the body (B). 6.
Mount the antenna whip se figure 4. 7.
PROCOM A/S reserve the right to amend specifications
without prior notice.
28/02/14