SCANTECH ID (Champtek company) SG300RFM - Manual (Page 9)

6
Keyboard Wedge
1. Turn off the host device.
2. Connect the 10-pin RJ45 male connector into the 10-pin
modular jack on the bottom of the cradle.
3. Disconnect the keyboard from host.
4. Connect the “Y” ends of the communication cable to the
keyboard and keyboard port on the host device. If necessary,
use the male/female adapter cable supplied with the scanner
for the proper connections.
5. Plug the external power supply into the power jack on the
bottom of the cradle.
6. Plug the power supply into the AC outlet. The red LED on the
rear of the cradle will stay on.
7. Turn on the host device.
8. Establish communication between the scanner and cradle.