GE Industrial Solutions CAR2024FP series - Manual (Page 3)

GE Energy
CAR2024FP series rectifier
Input: 90Vac to 264Vac; Output: 24Vdc @ 83A; 3.3Vdc or 5 Vdc @ 1A
March 28, 2013 ©2012 General Electric Company. All rights reserved. Page 3
24V
dc
MAIN OUTPUT (continued)
Parameter Device Symbol Min Typ Max Unit
Remote ON/OFF delay time All 40 ms
Turn-ON rise time (10 – 90% of V
out
)
All 60 ms
Transient response 50% step [10%-60%, 50% - 100%]
(dI/dt – 1A/
out
µs, recovery 300µs)
All
V
out
-5 +5 %V
out
Programmable range (hardware & software) All 21 29 V
dc
Overvoltage protection, latched
(recovery by cycling OFF/ON via hardware or software) All
30 31 32 V
dc
Output current V
in
= HL
V
in
= LL
All
I
out
0
83
50
A
dc
Current limit, Hiccup (programmable level) All 110 130 % of FL
Active current share All -5 +5 % of FL
AUXILIARY OUTPUT
Parameter Device Symbol Min Typ Max Unit
Set point All V
out
3.3 / 5.0 V
dc
Overall regulation (load, temperature, aging) All V
out
-5 +5 %
Ripple and noise All 50 mVp-p
Output current All I
out
0 1 A
dc
Overload protection -
Overvoltage protection
Isolation Output/Frame All 100 V
dc
Environmental, Reliability
Parameter Min Typ Max Units Notes
Ambient Temperature
Operating
Altitude Operating
Power Derating
-10 4 50
2250/7.4k
2.5
2.0
°C
m / ft
%/°C
C/1000 ft
Air inlet from sea level to 5,000 feet.
51°C to 70C
Above 5,000 ft
Storage
Altitude non-operating -40 85
8200/30k
°C
m / ft
Acoustic noise 55 dbA Full load
Over-temperature Protection 125/110 °C Shutdown / restart
Humidity Operating
Storage 30
10 95
95
%
Relative humidity, non-condensing
Shock and Vibration acceleration 6 Grms NEBS GR-63-CORE, Level 3, 20 -2000Hz, min 30 minutes
Earthquake Rating 4 Zone
NEBS GR-63-CORE, all floors, Seismic Zone 4 Designed
and tested to meet NEBS specifications.
Reliability 400,000 Hrs
Full load, 25C ; MTBF per SR232 Reliability protection
for electronic equipment, method I, case III,
Service Life 10 Yrs Full load, excluding fans
4 Designed to start at an ambient down to -40°C; meet spec after  30 min warm up period, may not meet operational limits below -10°C.