GE Industrial Solutions PEDESTAL FOR Unit Sizes 41 & 42 - Manual

This instruction sheet is for the installation of a pedestal unit available for the AF-6 series
drives in unit sizes 41 and 42. This is a 200mm high pedestal that allows these frames to
be floor mounted. The front of the pedestal has openings for input air to the power compo-
nents.
The drive gland plate must be installed to provide adequate cooling air to the control com-
ponents of the drive via the drive door fan and to maintain the IP21/NEMA1 or IP54/
NEMA12 degrees of enclosure protection.
INSTRUCTIONS
INSTALLATION OF PEDESTAL FOR UNIT SIZES 41& 42
Kit Contents
• Pedestal parts
• Primary pedestal frame
• Vented front cover
• Two side covers
• Two front brackets
• Hardware for assembly
•
Instruction manual
Required Tools
•
Socket wrench with 07mm to
17mm sockets
• T30 Torx Driver
Torque Requirements
M6 — 35 in-lbs (4.0 N-M)
M8 — 85 in-lbs (9.8 N-M)
M10 — 170 in-lbs(19.6 N-M)
177Rxxxx 12/2009 DET-721, Page 1
Table 1. Applicable Drives and Unit sizes
AF-6 Drive Frame
AF-600 FP 41, 42
AF-650 GP 41, 42
Table 2. Kit Part Numbers
AF-6 Frame Kit Part Number
41 and 42 OPC4XPED