GE Industrial Solutions PEDESTAL FOR Unit Sizes 41 & 42 - Manual (Page 3)

Install drive by lowering it on to the pedestal. The drive must
initially overhang the front of the pedestal to clear the retain-
ing bracket on the rear of the pedestal. After the drive is on
the pedestal, slide the drive to the rear until the slot in the
drive engages the retaining bracket on the pedestal.
Retaining
bracket
Slot
Secure the back of
drive with two M10
nuts
Retaining
bracket
Secure the front of the drive to the
pedestal with three M8 screws.
177Rxxxx 12/2009 DET-721, Page 3