GE Industrial Solutions EntelliGuard E Network Interlock for 800–2000 Ampere - Manual (Page 3)

Figure 3. Fastening the Network Interlock module to the
mounting plate.
Figure 4. Mounting the trip paddle assembly on the trip shaft.
Figure 5. Mounting the Network Interlock assembly to the circuit
breaker bottom frame. (Shunt Trip omitted for clarity.)
Figure 6. Trip paddle and set lever gap calibration. (Breaker
charged. NI module shown in RESET position.)
Bottom Frame
Mounting Plate
Reset Solenoid
Set Solenoid
0.06” - 0.09”
Reset Lever
Set Lever
Trip Paddle
Adjusting
Screw
0.34”
Paddle Clamp
Trip Paddle
Trip Shaft