GE Industrial Solutions J85480S1, L20 – L29 Compact Power Line Shelves - Manual (Page 6)

6 of 8
COMPACT POWER LINE SHELVES – MODEL J85480S1
Support Tools
Graphical User Interface This program exercises the various
commands and functions available via the i
2
C
interface of the power supply. Two
independent GUIs can demonstrate the two
independent i
2 C multiplexed lines . Find out
who is in control, take over control.
The GUI has an automated polling feature
and records all state changes in a time
stamped automated fashion. Monitoring of
the power system is therefore trivial for long
periods of time.
Interface Board This board can be used independently or in
combination with the GUI interface
LEDs display the status of the analog signals
and dip switches change the signal state to
the power supply.
In addition, two connectors are provided for
interfacing to the two i
2 C lines of the power
supplies.
Total Communications
Solution This is a nuts and bolts complete hardware
solution that starts from either the USB or
RS232 port of a computer and ends with a
cable set that connects into the J1 signal
connector of the shelf.
In between is the interface board and a
commercially available converter that
translates the computer signals into i
2
C and
vice versa.
The converter is an MIIC-202 IPort
manufactured by Micro Computer Control
(mcc-us.com).
Safety
Product Labeling
Follow all warnings and instructions marked on the product. Some of the safety symbols used with the CP platform
of rectifiers and J85480S1 Shelf may include the following. They may also be accompanied by instructions:
Mounting and Installation
• This product shall be installed in compliance with mounting requirements for the ultimate application.
• This product must be installed, serviced, and operated only by skilled and qualified personnel who have the necessary
knowledge and practical experience with electrical equipment and who understand the hazards that can arise when working on
this type of equipment. This product is intended for use in a Restricted Access Location.
• This equipment is to be used in controlled environments (an area where the humidity is maintained at levels that cannot cause
condensation on the equipment, the contaminating dust is controlled, and the steady-state ambient temperature is within the range
specified).
• This equipment has been evaluated for use in a continuous ambient temperature of up to 55°C and the application environment
should not exceed 55°C.