GE Industrial Solutions A Series Lighting Control Panelboards Handheld Programmer ASRGLCHPK - Manual (Page 2)

7
Application ....................................................................................................4
Menu Structure ............................................................................................4
Menu Descriptions.......................................................................................4
Schedules .............................................................................................................................................. 4
Calendar ............................................................................................................................................... 4
I/O Menu ............................................................................................................................................. 4
Lighting Group.................................................................................................................................... 4
Dimming Menu ................................................................................................................................... 4
Burn Hours Menu ............................................................................................................................... 4
Breaker Override Menu ..................................................................................................................... 4
Configuration Menu........................................................................................................................... 4
Event Menu .......................................................................................................................................... 3
Set Password. This function sets the
password for the current user.
Reset MSP430. This function resets the
back plane of the controller. Note that
this item should only be used for instant
remapping of the breaker or for
diagnostic purposes.
Reconfig Net. T h i s f u n c t i o n
reconfigures the controller’s address
using DNA. This is done when the
controller is first connected to the
network; since it is a subnet device, it
inherits the address of the master above.
For example, if the master address is 100
and the address of the subnet is 1,
Reconfig Net sets the address to 101.
Reset Device. This function performs a
hardware reset of the controller.
Save Flash. This function saves the
changes made to flash memory so they
can be reloaded if the battery goes dead
or to return to the previous version.
Load Flash. This function loads the
database with the last version saved to
flash memory. It overwrites the current
contents of the database and performs a
hardware reset.
Event Menu
These menu items are used to
acknowledge alarms, view battery status,
view or reset the CE Log, and set up the
CE Log. The CE log captures the events
listed in Table 1.
Event Display
Alarm ALARM
Alarm Acknowledged ALARM ACK
Dead Battery DEAD BATT
Dead Battery
Restored DEAD BATT
RESTORED
Command Failure CMD FAIL
Command Fail
Restored CMD FAIL
RESTORED
Status ON STATUS ON
Status OFF STATUS OFF
Under Voltage UNDER VOLT
Under Voltage
Restored UNDER VOLT
RESTORED
Reset DEV RESET
Time / Date change TIME CHG
DB Load DB LOAD
DB Save DB SAVE
DB Clear DB CLEAR
Lnk Online DEV ONLINE
Lnk Offline DEV OFFLINE
Breaker Trip BREAKER TRIP
Breaker Trip
Restored BREAKER TRIP
RESTORED
No events occurred NONE
Table 1. Events captured in the CE Log.