SoundMax SM-DVD5112 - Manual (Page 9)

9
Connection
Note: Before you start connection of external devices, ensure that power of the unit is switched off.
Following outputs are available in this unit:
Composite video
Use the cable with yellow plug of an AV cable to connect the composite video output of this unit to the video
input of a TV/monitor.
Component video
Use a 3-core AV cable to connect the component output of this unit to the corresponding input of your
TV/monitor.
S-video
Use an S-video cable to connect the S-Video output of this unit to the S-Video input of your TV/monitor.
SCART
Use a 21-pin SCART cable to connect the SCART output of this unit to the TV/monitor SCART input.
5.1CH audio
Use 3 pairs of audio cables to connect the 5.1 CH audio outputs of this unit to the 5.1 channel inputs of
external audio amplifiers or other players.
Stereo audio
Use a pair of AV cables (red for right/white for left) to connect the stereo audio outputs of this unit to the TV
or a stereo input of power amplifier.
Coaxial digital audio
Use a special coaxial cable to connect the coaxial output of this unit to the coaxial input of a power amplifier.
Optical digital audio
Use a special optical cable to connect the coaxial output of this unit to the optical input of a power amplifier.
MIC jack
MIC jack is used to connect a microphone (not included) to this unit.
Notes: The connection you should make depends on the TV/monitor input terminals. Don’t make all the
connections at the same time; otherwise the produced picture will be affected. The physical connection should
accord to the audio output setup of this unit.