GE Industrial Solutions EntelliGuard G Pushbutton Padlock Device - Manual (Page 2)

6. To Reinstall the cover, rotate the charging
handle down and slide the front cover over the
handle to assemble the front cover to housing as
shown in Fig. 5.
Figure 2.
4. Fix the Padlocking device kit with fascia using
the screws provided refer Fig. 3
Screw
Figure 5.
7. Ensure the fascia is aligned properly with the
trip unit and the pad lock features of the breaker.
Figure 3: Assembly of Padlock Device
5 . Raise the appropriate windows of ON/OFF
8. Fasten the 6 mounting screws of fascia with
the housing using a pozidrive screwdriver. Apply
torque of 6 Nm (4.42 ft-lbs).
buttons. Install padlock hasp through the locking
eye (Fig. 4).
Padlock hasp can be of 3 to 8mm
diameter.
Figure 4: Fixing the screws
2