GE Industrial Solutions EntelliGuard G Pushbutton Padlock Device - Manual

Introduction
Pushbutton Padlock Device:
The optional pack contains a Pushbutton lock
kit, which has to be fixed in the fascia.
It denies unauthorized access to the ON/OFF
Pushbuttons.
Cat No. GPBDR
Use the following procedure to install the
Pushbutton Padlock Device accessory into the
circuit breaker.
1. Turn the breaker off and discharge the closing
springs by depressing the OFF and ON buttons in
the sequence OFF-ON-OFF. Verify that the
breaker OFF-ON indicator shows OFF on a green
background and that the charge indicator shows
DISCHARGE on a white background. If installing
in a draw-out type breaker remove breaker from
adaptor (cassette) before continuing.
DEH-41414 Installation Instructions
EntelliGuard ® G Circuit Breaker
Accessories
Pushbutton Padlock Device
WARNING: Before installing any accessories, turn the
breaker OFF, disconnect it from all voltage sources,
and discharge the closing spings.
2. Loosen the 6 screws on front cover (fascia)
using a posidrive screw driver as shown in Fig 1.B
Rotate the charging handle down and slide the
front cover over the handle to remove the front
cover as shown in Fig. 1.C.
Figure 1. (A) Front Cover (B) ScrewRemoval (C) Handle
Rotation
3. Knock out the regions shown in Fig. 2 in fascia
to locate the push button lock kit.
AVERTISSEMENT: Avant d’installer tout accessoire,
mettre le disjoncteur en position OFF, le déconnecter
de toute tension d’alimentation , et décharger les
resorts d’armement
1