GE Industrial Solutions Spectra Series ADF Dead Fronts & Type APF Door Fronts - Manual (Page 3)

Figure 7. Installing the dead front load and line ends to an interior
with main lugs.
3. Turn the latches on the ends of the dead front line
end [3] and load end [2] so that the slot openings are
clear. Align the flanges on the dead front end side
panels [4] into the slots on the ends, as shown in
Figure 8. Turn the latches a quarter turn to secure the
end panels. Figure 9 shows the completed dead front
assembly.
Figure 8. Installing the dead front side panels to the line and load
ends.
Figure 9. Completed dead front assembly.
Installing the Door Front
4. Orient the door with the hinges to the right, as shown
in Figure 10. Align the door with the enclosure side
walls, and rest the welded brackets located at the lower
back side of the door on the enclosure end wall, as
illustrated in Figure 11. Fasten the door to the
enclosure with the #10-32 x
11 / 16 -in. self-tapping
screws provided. Tighten all screws to 25–30 in.
Figure 10. Installing the door front.
Hinge
Reference
Figure 11
6
2
3
11
Main Lug
Bracket
2
4
4
3
Latch
Door
Screw