GE Industrial Solutions EntelliGuard G Wall mounting Kit - Manual (Page 2)

4. Assemble the LH and RH mounting plate using
the screws removed from the Breaker as shown
in fig. 3.
Figure 3
5. To reinstall the cover, rotate the charging
handle down and slide the front cover over the
handle to assemble the front cover to housing as
shown in Fig. 4
6. Ensure the fascia is aligned properly with the
trip unit and the pad lock features of the breaker
7. Fasten the 6 mounting screws of fascia with
the housing using a pozidrive screwdriver as
shown in Fig. 4. Apply torque of 6 Nm (4.42 ft-lbs).
Assemble fixing screws
Figure 4
These instructions do not purport to cover all details or variations in equipment nor, to provide contingency to be met in connection
with installation, operation, or maintenance. Should further information be desired, or should particular problems arise which are not
covered sufficiently for the purchaser’s purposes, the matter should be referred to GE.
GE
41 Woodford Ave, Plainville, CT 06062
www.geelectrical.com
© 2009 General Electric Company
DEH-41383 R1 (04/09)
2