GE Industrial Solutions Spectra K-Frame MCCB with microEntelliGuard trip unit - Manual (Page 3)

GEH-701 Instructions
3. Install any internal accessories, following the
instructions supplied with each accessory. Available
accessories and their mounting locations are
listed in Table 3. Check all accessories for proper
installation and wire routing. Verify breaker
operation with the installed accessories. Accessory
leads can be routed along the side of the breaker
and across the back. An auxiliary switch is required
for the breaker status signal.
Table 3. Internal Accessories
Internal Accessory
Maximum
Number of
Accessories
Accessory
Installation
Location
Auxiliary Switch
(SPDT or DPDT)
1 Right
Bell Alarm Switch 1 Left
Shunt Trip or
Undervoltage Release
1 Left
4. Attach the terminal lugs, listed in Table 4, following the
instructions supplied with the lugs.
Table 4. Available Lugs
Catalog Number Description Wire Type Lug Material
TCAL81 800A Lug
Cu/Al
Tin-plated
aluminum TCAL125 1200A Lug
TCO81A 800A Lug
Cu only
Tin-plated
copper TCO125 1200A Lug
5. Ensure that all terminals are torqued to the proper
value, as listed in the lug kit instruction sheet . Install
the terminal covers, ensuring that they are firmly
seated.
NOTE: Aluminum wire must be used with a joint
compound recommended by the wire manufacturer.
WARNING: It is important that the terminal covers are
installed correctly to ensure proper circuit breaker
operation.
IMPORTANT: Il est important de vérifier que tous
couvercles ou caches de protection sont correctement
installés afin d’assurer le bon fonctionnement de l’appareil.
NOTE: The SKP and SKS Frames (100kA , 480V) have a
longer terminal cover for the upper (line) The top portion
of this cover must be installed after cable or bus
installation. Do not substitute the shorter lug cover.
IMPORTANT: Un caches-bornes plus long est spécifique
au bout supérieur des disjoncteurs SKP et SKS (100kA ,
480V). Le haute de ce cachebarnes doit être monté après
d’installer Ie câble ou Ie bus. Ne substituez pas un cache-
bornes plus court .
6. Finally, connect all associated components that are
required for the breaker to function properly, using
the instructions supplied with each component .
The following is a list of available associated
components:
• Terminal board connector
• Neutral current sensor connector
• Control power connector
• Extension cable
• Control power module (control power transformer
may be required)
• Voltage conditioners (potential transformers may
be required)
• Voltage module
• Neutral current sensor
IMPORTANT: Si un cable en aluminum est employé,
utilisez le lubrifiant recommandé par le fabricant .
Mounting
All Spectra ® RMS circuit breakers are suitable for
reverse feed and no line or load markings.
Incoming power cables or busbars may be
connected to either the upper or lower terminals
as required by the application