GE Industrial Solutions AF-600 FP Panel Through Mount Kit - Manual (Page 8)

1.4 Assembly
1.4.1 Assembly of Mounting Flange to Drive
Illustration 1.6: Fitting of sealing
The flange should now be assembled to the drive using the supplied screws and captive washers. The screws should be tightened to a torque of 2.2 – 2.5 NM,
using a Torx-20 tool.
NB!
If the drive is to be mounted through the front of the panel, the flange must be assembled so that the raised edge of the flange is uppermost (towards the
electronics). If the drive is to be mounted from the rear of the panel, then the flange should be fitted with the raised edge facing away from the electronics.
AF-650 GP/AF-600 FP Panel Through Mount Kit
7
1